Technician A says that the pitman arm is connected to the steering gear. Technician B says that an idler arm is used with all rack and pinion steering linkages. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians A and B D) Neither technician A nor B
Question 2
New tie rods are being installed. Technician A says to tighten the retaining nuts to specification and then loosen, if needed, to align the cotter pin hole. Technician B says to tighten farther to align the cotter key hole. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians A and B D) Neither technician A nor B
Major trunk lines carrying long-distance traffic crisscrossed the area east of the Mississippi. The
The technician is using a feeler gauge that is onethousandth of an inch thinner and another ...
To use a battery charger, make sure the charger is connected to the battery before plugging in the ...
A schematic showing that an inertia switch is connected in series between the fuel-pump relay and ...
Notice the small motor gear on the left drives a larger plastic gear (black), which then drives ...
A digital storage oscilloscope can be easily connected to an injector by carefully back-probing ...