Technician A says that the pitman arm is connected to the steering gear. Technician B says that an idler arm is used with all rack and pinion steering linkages. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians A and B D) Neither technician A nor B
Question 2
New tie rods are being installed. Technician A says to tighten the retaining nuts to specification and then loosen, if needed, to align the cotter pin hole. Technician B says to tighten farther to align the cotter key hole. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians A and B D) Neither technician A nor B
The oil pressure switch is connected to a warning lamp that alerts the driver of low oil pressure.
To help locate how far the engine is being rotated, the technician is removing the distributor cap ...
A schematic showing that an inertia switch is connected in series between the fuel-pump relay and ...
Notice the small motor gear on the left drives a larger plastic gear (black), which then drives ...
Getting Connected
A 23 kg mass is connected to a nail on a frictionless table by a massless string 1.3 m long. ...