[Answered] The minimum cut when machining a drum or rotor should be _______

This topic contains a solution. Click here to go to the answer

Author Question: The minimum cut when machining a drum or rotor should be ________. A) 0.002 inch B) 0.0005 inch ... (Read 138 times)

rl

Hero Member
Posts: 579

on: Jun 23, 2018

The minimum cut when machining a drum or rotor should be ________.

A) 0.002 inch B) 0.0005 inch C) 0.020 inch D) 0.600 inch

Question 2

Using a ________ when turning a drum prevents tool chatter.

A) Reverse thread B) High speed C) Soft tool bit D) Silencer band

Need homework help now?

Ask unlimited questions for free

Ask a Question

Marked as best answer by a Subject Expert

tandmlomax84

Sr. Member
Posts: 323

Reply #1 on: Jun 23, 2018

Answer to Question 1

A

Answer to Question 2

D

rl

Member
Posts: 579

Reply 2 on: Jun 23, 2018

Gracias!

mochi09

Member
Posts: 335

Reply 3 on: Yesterday

Wow, this really help

« previous next »

Did you know?

Pubic lice (crabs) are usually spread through sexual contact. You cannot catch them by using a public toilet.

Did you know?

Asthma is the most common chronic childhood disease in the world. Most children who develop asthma have symptoms before they are 5 years old.

Did you know?

ACTH levels are normally highest in the early morning (between 6 and 8 A.M.) and lowest in the evening (between 6 and 11 P.M.). Therefore, a doctor who suspects abnormal levels looks for low ACTH in the morning and high ACTH in the evening.

Did you know?

It is difficult to obtain enough calcium without consuming milk or other dairy foods.

Did you know?

Drug abusers experience the following scenario: The pleasure given by their drug (or drugs) of choice is so strong that it is difficult to eradicate even after years of staying away from the substances involved. Certain triggers may cause a drug abuser to relapse. Research shows that long-term drug abuse results in significant changes in brain function that persist long after an individual stops using drugs. It is most important to realize that the same is true of not just illegal substances but alcohol and tobacco as well.

A typical 1/2 inch drive air impact wrench. The direction of rotation can be changed to loosen or ...

A CO2 fire extinguisher being used on a fire set in an open drum during a demonstration at a fire ...

The operation of a rotor-type oil pump.

A close-up showing the recessed center electrode on a spark tester. It is recessed 3/8 inch into ...

Since 1991, General Motors engines have been equipped with slightly (1/8 inch or 3 mm) longer spark ...

The enthalpy change for converting 10.0 g of ice at -25.0 C to water at 80.0 C is ________ kJ. ...

Author Question: The minimum cut when machining a drum or rotor should be ________. A) 0.002 inch B) 0.0005 inch ... (Read 138 times)

rl

The minimum cut when machining a drum or rotor should be ________. A) 0.002 inch B) 0.0005 inch ...

Related Topics

Need homework help now?

tandmlomax84

The minimum cut when machining a drum or rotor should be ________. A) 0.002 inch B) 0.0005 inch ...

rl

mochi09