[Answered] The minimum cut when machining a drum or rotor should be _______

This topic contains a solution. Click here to go to the answer

Author Question: The minimum cut when machining a drum or rotor should be ________. A) 0.002 inch B) 0.0005 inch ... (Read 144 times)

rl

Hero Member
Posts: 579

on: Jun 23, 2018

The minimum cut when machining a drum or rotor should be ________.

A) 0.002 inch B) 0.0005 inch C) 0.020 inch D) 0.600 inch

Question 2

Using a ________ when turning a drum prevents tool chatter.

A) Reverse thread B) High speed C) Soft tool bit D) Silencer band

Need homework help now?

Ask unlimited questions for free

Ask a Question

Marked as best answer by a Subject Expert

tandmlomax84

Sr. Member
Posts: 323

Reply #1 on: Jun 23, 2018

Answer to Question 1

A

Answer to Question 2

D

rl

Member
Posts: 579

Reply 2 on: Jun 23, 2018

Gracias!

laurnthompson

Member
Posts: 334

Reply 3 on: Yesterday

TYSM

« previous next »

Did you know?

The first oncogene was discovered in 1970 and was termed SRC (pronounced "SARK").

Did you know?

Although puberty usually occurs in the early teenage years, the world's youngest parents were two Chinese children who had their first baby when they were 8 and 9 years of age.

Did you know?

People with alcoholism are at a much greater risk of malnutrition than are other people and usually exhibit low levels of most vitamins (especially folic acid). This is because alcohol often takes the place of 50% of their daily intake of calories, with little nutritional value contained in it.

Did you know?

In the ancient and medieval periods, dysentery killed about ? of all babies before they reach 12 months of age. The disease was transferred through contaminated drinking water, because there was no way to adequately dispose of sewage, which contaminated the water.

Did you know?

Human kidneys will clean about 1 million gallons of blood in an average lifetime.

On some engines, it is necessary to watch the direction the rotor is pointing to help determine how ...

A light shield over an optical sensor being installed before the rotor is attached.

The enthalpy change for converting 10.0 g of ice at -25.0 C to water at 80.0 C is ________ kJ. ...

$How wide must a narrow slit be if the first diffraction minimum occurs at 12 with laser light ...$ How wide must a narrow slit be if the first diffraction minimum occurs at 12 with laser light ...

The drum shown in the figure has a radius of 0.40 m and a moment of inertia of 2.3 kg m2about ...

What is the minimum number of straight, continuous lines that are necessary to c

Author Question: The minimum cut when machining a drum or rotor should be ________. A) 0.002 inch B) 0.0005 inch ... (Read 144 times)

rl

The minimum cut when machining a drum or rotor should be ________. A) 0.002 inch B) 0.0005 inch ...

Related Topics

Need homework help now?

tandmlomax84

The minimum cut when machining a drum or rotor should be ________. A) 0.002 inch B) 0.0005 inch ...

rl

laurnthompson