[Answered] The minimum cut when machining a drum or rotor should be _______

This topic contains a solution. Click here to go to the answer

Author Question: The minimum cut when machining a drum or rotor should be ________. A) 0.002 inch B) 0.0005 inch ... (Read 145 times)

rl

Hero Member
Posts: 579

on: Jun 23, 2018

The minimum cut when machining a drum or rotor should be ________.

A) 0.002 inch B) 0.0005 inch C) 0.020 inch D) 0.600 inch

Question 2

Using a ________ when turning a drum prevents tool chatter.

A) Reverse thread B) High speed C) Soft tool bit D) Silencer band

Need homework help now?

Ask unlimited questions for free

Ask a Question

Marked as best answer by a Subject Expert

tandmlomax84

Sr. Member
Posts: 323

Reply #1 on: Jun 23, 2018

Answer to Question 1

A

Answer to Question 2

D

rl

Member
Posts: 579

Reply 2 on: Jun 23, 2018

Gracias!

dreamfighter72

Member
Posts: 355

Reply 3 on: Yesterday

Excellent

« previous next »

Did you know?

Hypertension is a silent killer because it is deadly and has no significant early symptoms. The danger from hypertension is the extra load on the heart, which can lead to hypertensive heart disease and kidney damage. This occurs without any major symptoms until the high blood pressure becomes extreme. Regular blood pressure checks are an important method of catching hypertension before it can kill you.

Did you know?

Cyanide works by making the human body unable to use oxygen.

Did you know?

Eating food that has been cooked with poppy seeds may cause you to fail a drug screening test, because the seeds contain enough opiate alkaloids to register as a positive.

Did you know?

Approximately one in three babies in the United States is now delivered by cesarean section. The number of cesarean sections in the United States has risen 46% since 1996.

Did you know?

In 2006, a generic antinausea drug named ondansetron was approved. It is used to stop nausea and vomiting associated with surgery, chemotherapy, and radiation therapy.

The operation of a rotor-type oil pump.

A close-up showing the recessed center electrode on a spark tester. It is recessed 3/8 inch into ...

Since 1991, General Motors engines have been equipped with slightly (1/8 inch or 3 mm) longer spark ...

How to find the maximum and minimum of a quadratic relation

How to determine if a quadratic equation has a maximum or minimum when given the roots

Comparison of Alpha Modified Eagle’s Minimum Essential Medium with Dulbecco’s Modified Eagle’s ...

Author Question: The minimum cut when machining a drum or rotor should be ________. A) 0.002 inch B) 0.0005 inch ... (Read 145 times)

rl

The minimum cut when machining a drum or rotor should be ________. A) 0.002 inch B) 0.0005 inch ...

Related Topics

Need homework help now?

tandmlomax84

The minimum cut when machining a drum or rotor should be ________. A) 0.002 inch B) 0.0005 inch ...

rl

dreamfighter72